Shop Categories

Product Details

 5V 1A Micro USB Lithium Battery Charging TP4056 balance Charger 18650 Protection
5V 1A Micro USB Lithium Battery Charging TP4056 balance Charger 18650 Protection
MPN :
SKU : USBCHG02-H40
Stock : 361pcs
Price:PKR 80.00
5V 1A Micro USB Lithium Battery Charging Board TP4056 balance Charger Module


Note: The first time you access the battery, it may no voltage between the output OUT + and OUT-, then access 5V voltage charge your energy can activate the protection circuit, and the battery from the B+ B-, then draw a line on the short open also need recharged to activate the protection circuit. Note that the charger must be able to output 1A or more to do when using a mobile phone charger input, or may not charge.


+ MICRO USB female and next - pads for the power input, access 5V. B + positive then the lithium battery, B- then negative lithium batteries. OUT + and OUT- connected to the load, such as positive and negative electrodes connected mobile booster plate or other load.


Connect the battery to the B + B-, inserted into the USB female mobile phone charger, the red light is being charged, the green light to full.


Product Introduction:
1.Input Voltage: 5V Micro USB 
2.Charging Cut-Off Voltage: 4.2V±1%
3.Maximum Charging Current: 1000mA
4.Overdischarging Protection Voltage: 2.5V
5.Overcurret Protection Current: 3A
6.Board Size: 2.6*1.7cm


Notice:
1. Testing Current Meter can only serial connect with charging board 5V input port
2. Charging current should be battery capacity 0.37C,that is 0.37 times
3. Charging connecting cable should not be too thin and long
4. Make Sure that connecting with battery perfectly
5. If 5V input voltage is a little high, such as 5.2V or 5.5V,it will cause charging current cannot reach 1000MA.This is normal phenomenon.
6. Input transposition hasn't impact on chip; but output transposition will burn the chip
  • Google Checkout
  • Master Card
  • Paypal
  • Acc
  • Acc2
  • Visa

Copyright © 2014, All rights reserved.