Powerful 15000mW 15W 450nm 12v LASER module  blue laser engraving machine accessories 15000mw engravable stainless steel


Made of high quality hard aluminum and brass material, the surface is by anodizedand sandblasting , not easy rust,very durable.
One of the most powerful diodes available, upgrade your Wood engraver to a Metal Marking Machine.
It can mark metal and stone, cut wood, foam and other materials easily.
With heat dissipation fan,make it with longer service life.
TTL and PWM is compatible, it can run only one of them at the meanwhile


Can Engrave: MDF/Balsa/Paper/Wood/Fabric/Plastic/Leather/
Cork Wood/Foam Paper/Anodized Aluminum/ Ceramics/Stone/Stainless steel
Can Not Engrave : Metal/Glass/PCB/Reflective Material/ Transparent Material


Technical Parameters:
Laser wavelength: 450nm (blue-violet light)
Optical power: 15W (15000MW)
Drive mode: external ACC constant current drive
Cooling method: forced air cooling
Operating voltage: 12 V DC
Material: aluminum, surface anodized
Cooling method: forced air cooling
Operating voltage: 12V  DC
Control interface: 2 * 2.54 (TTL control switch, PWM control power)
Material form: Copper
Laser focal length is not adjustable, focal length is 1.8cm
Working temperature: -40-75 degrees Celsius


Tips: This 15W fixed focus laser can be engraved on stainless steel surface and anode colored aluminum alloy surface, and it can cut 3mm wood board.


15000mW LASER x 1
3PIN CABLE x 1
3PIN to 2P+2P x 1
SAFETY GLASSES x 1
we send heat sink and black heat sink randomly


NOTICE:
- Please wear the protective glass when you use the laser module.
- Do not touching the laser light directly in case that hurt the body and skin.
- Keep children and pets away from the laser module when it working.
- The Laser dot could not be adjusted, please make sure the distance between bottom of the
laser module and engraving material is 16mm(Use the plastic column to do it). Or it will influence the result.
- Please connect to the driver board carefully! The Red cord is 12V+, the black cord is GND-, the yellow cord is Signal(S). Please make sure you know how to connect it. Or it might damage the laser module!
- Any quality problem, please send a detailed video to us with a problem description. Please DO NOT disassemble the laser module without our permission, or it might cause the damage. Thank you.